Trouble shooting

Trouble Shooting

Installation

Operation

One test station works normal and the other one shows fault
- When it comes that one test station works ok and the other one not, please check the wire connection first, to see if there is any loose connection on the abnormal side.
  More
Insulation resistance value varies frequently
- If the operator find that the IR value varies frequently, please check weather there is some copper chops inside the test clamps, or check the ambient humidity,
  More
Tester remind “GND abnormal”
- When the window of Ground error or GND abnormal pops-up, please contact the maintenance man,
  More
First time power on and LCD monitor not powered
- If the LCD screen doesn’t light up after power on, please check the control power air switch, switch on B0AA PCB and check the E-stop push button, make sure all the switches are close loop in the circuit.
  More
IPC and test unit communication not connected
- When the testing can not be started, and the net status shows unconnected, operator should power off the whole tester by press the E-stop button,
  More
Test cannot be started
- If the testing can not be start, and the software shows no abnormal, please check the start mode setting.
  More
How to calibrate screen
- When the screen mouse drift occurs,
  More
Method of replacing test module board
- Loosen the screws fixing the upper and lower board cards with a screwdriver.
  More